Forgot password
Order status
Free delivery from 150 euro
Motorcycle parts
Honda VT 500 E 1984
Manufacturer
Price
Sort
Options +3 
€10.89
JMP sponge air filter
€12.13
Clutch cable
€10.65
Lowest price from 30 days before discount: €11.21
Athena 6202 2RS1 C3 SKF wheel bearing - MS150350110M3
€17.00
Lowest price from 30 days before discount: €17.89
Athena 6303 2RS1 SKF wheel bearing - MS170470140DD
€1.06
JMP 12V 4W BA9S bulb
from 3
Browse by manufacturer
Products reviews
Used for Honda FT 500 1983. Fitted within the hour (after disassembly & preparation = removal of old bearings). Have used 50 mm pvc pipe to drive bottom cup in; tightness of fit was as it should be. Did not use the supplied washer but made my own of 30x36x3 mm so the original rubber seal could sit below the (inner part of) the bearing. Re-used the original bottom washer (0.8 mm thick) to shield the seal. The (upper) adjustment nut also carries a thin shield. I had to grind the spigot (for the shield, on the nut) to a chamfer, as it just touched the radius of the upper bearing inner ring. On the 3rd picture, where the shield lies under the nut: red arrows = grind inner dia of spigot, shield fits at outer dia (on top as depicted). Ordered a 2nd set for my Honda XBR 500.
Review translated automatically
Reliable opinion
CB 750 SevenFifty. (RC 42 year 1995) The handles fit perfectly! I recommend. Very easy to install, great diameter fit.
Review translated automatically
Reliable opinion
Professionally made instrument, a must have for every DIY enthusiast as well as a professional for the garage.
Review translated automatically
Reliable opinion
For my Hondas FT 500 (1983) & XBR 500 (1986) as spares. Remove the lever first, then punch out the old one from the contact pins side; it's an easy, light press fit. When pressing in the new one, align the hook on the switch with the notch in the clutch lever body. Note the hole in the switch also lines up with a hole at the underside of the alu body; it's for contact spray when needed. (Better use it before needed; once corroded the inner contact becomes difficult).
Review translated automatically
Reliable opinion
Affairs, it conducts electricity. However, it does not fit the 1976 GL1000 K1 model, as it has a larger diameter than the original (factory) and will not go into the hole in the handle holder. I had to take the original one apart despite the damage and was able to repair it. Perhaps this one will fit the specified GL1000 78-79 but I will check this when I give it to a colleague. It would be good to have the basic dimensions plotted on the parts in the photo to see if it will fit us.
Review translated automatically
Reliable opinion
I have always dreamed of something like this. Finally I could clean the nozzles thoroughly. amol the tips are so sharp that even if you try, you can enlarge the hole in the nozzle to a given size. So not only cleans, but if you want to enlarge the holes. I recommend 100%
Review translated automatically
Reliable opinion
Conforms to the original...very satisfied! I recommend this shopping site and will return. On the other hand, asking you to write a comment of at least 100 characters isn't cool...I imagine a lot of people give up.
Review translated automatically
Reliable opinion