Forgot password
Order status
Free delivery from 150 euro
Motorcycle parts
Honda VT 750 CA Shadow 2007
Manufacturer
Price
Sort
Options +6 
€21.92
Lowest price from 30 days before discount: €27.40
Fits on the frontEBC FA 196 V brake pads (2 pcs.)
(9) 
€16.58
Gas cable A
€16.58
Gas cable B
€152.19
Lowest price from 30 days before discount: €160.20
delivery 0 €EBC MD 1159 brake disc - MD1159
Options +6 €19.77
Lowest price from 30 days before discount: €24.72
Fits on the frontEBC FA 196 brake pads (2 pcs.)
(9) 
from 4
Browse by manufacturer
Products reviews
The battery meets all expectations, with exactly the right voltage and current. The size corresponds exactly to the box in which it is to be inserted. The contacts are perfectly fine, so the installation was completely in line with the motorcycle and the service technician's requirements. I therefore recommend the battery as a great buy at a very reasonable price.
Review translated automatically
Reliable opinion
The screw is made with precision. I just pay attention to the assembly! The original screw is at least twice as long. The torque recommended in the service book (43Nm) is far too much for a Yamaha Thundercat, fekt is a broken thread.
Review translated automatically
Reliable opinion
Very good quality. Fits suspension that even the factory did not have covers, fits Suzuki Bandit GSF600 1999 (prelift). I recommend the set
Review translated automatically
Reliable opinion
Professionally made instrument, a must have for every DIY enthusiast as well as a professional for the garage.
Review translated automatically
Reliable opinion
For my Hondas FT 500 (1983) & XBR 500 (1986) as spares. Remove the lever first, then punch out the old one from the contact pins side; it's an easy, light press fit. When pressing in the new one, align the hook on the switch with the notch in the clutch lever body. Note the hole in the switch also lines up with a hole at the underside of the alu body; it's for contact spray when needed. (Better use it before needed; once corroded the inner contact becomes difficult).
Review translated automatically
Reliable opinion
Affairs, it conducts electricity. However, it does not fit the 1976 GL1000 K1 model, as it has a larger diameter than the original (factory) and will not go into the hole in the handle holder. I had to take the original one apart despite the damage and was able to repair it. Perhaps this one will fit the specified GL1000 78-79 but I will check this when I give it to a colleague. It would be good to have the basic dimensions plotted on the parts in the photo to see if it will fit us.
Review translated automatically
Reliable opinion
Very good quality workmanship and high compatibility with the original Honda. The automatic fits perfectly to the unlisted matching model Honda CBZ 125F (1998) (who has it knows how hard it is to find any parts in catalogs for it). After installation, it fits without backlash, and the switch itself works smoothly and without jamming. Recommended.
Review translated automatically
Reliable opinion
Hello, I recently purchased some bearings shown in the ad. They were mounted to the scythe in the mtd tractor. SKF bearings have good strength and fit perfectly in the places for them. The advantage of the product is all kinds of uses, they perform well in any equipment. I recommend to purchase this product. Greetings
Review translated automatically
Reliable opinion
In my motorcycle, the installation of pads is the proverbial 5 minutes, you can do it without removing the caliper .Pads, I bought organic because they are softer .Maybe they wear out faster, but the disc lives longer .Fitting is good, no problem and nothing needs to be adjusted.Overall I am satisfied.
Review translated automatically
Reliable opinion
The product is very similar to the original. The only fault is that the threaded end is too short compared to the original. It's missing about 5 to 8 mm. This damaged the threads on my housing. I had to dismantle everything and redo the threading with ilsert.
Review translated automatically
Reliable opinion
I have always dreamed of something like this. Finally I could clean the nozzles thoroughly. amol the tips are so sharp that even if you try, you can enlarge the hole in the nozzle to a given size. So not only cleans, but if you want to enlarge the holes. I recommend 100%
Review translated automatically
Reliable opinion
When purchased, the bearing had no play, as befits a new bearing. The bearing has many uses. They can be mounted to wheels that are equipped with a drive on which a very high force acts. This bearing will 100% last more than a typical Chinese bearing.
Review translated automatically
Reliable opinion
The pan fit the 1995 Suzuki DR 650 RSE without the slightest problem. Perhaps the biggest advantage of the product and the store as such is how easy it is to find a specific part for your motorcycle.
Review translated automatically
Reliable opinion
Product conforms to the order and the description, delivery a little long but in view of the end of year festivities, this can be explained. Responsive when messages sent for this order to be received
Review translated automatically
Reliable opinion
Yamaha XVS 1300 CU year 2014 The bolt is shorter than the original and does not hold the size of the original bolt. It should not be indicated to fit this model. The only use for it is a copper gasket.
Review translated automatically
Reliable opinion
The battery is ideal. Fell right for Honda Shadow C2 750. And the charger arrived, hopefully I won't have to use the charger.
Review translated automatically
Reliable opinion