Forgot password
Order status
Free delivery from 150 euro
Motorcycle parts
Junak 901 RS 50 4T - Page 3
Manufacturer
Price
Sort
from 6
Browse by manufacturer
Products reviews
Hello I own a junak 901 with a capacity of 50/70cmm from new purchased in 2011 to date Junak has traveled nearly 17 thousand km What I really like about the moped is the simplicity of the whole motorcycle, there is nothing complicated in the repair process, simple design, availability of parts is huge and easy to obtain. This is the second repair of the engine since new due to the fact that I ride a lot, parts wear out, now I have overhauled the engine again and the motor fires up from a shot, the larger gear ratio gears allowed to run longer in gear and achieve better results speed in km ends as soon as the pointer passes 80 I like to test various products with them especially carburetors and filters to get better results in combustion and on power of course it is possible but several carburetors of different manufacturers of fuel nozzles you need to have to get such an effect . Parts from gmoto I buy because it is a proven seller of parts and really parts are of very good quality than on other sites only now what I bought starter chain sliders significantly differ from the original I would say more that the quality and material are other weaker but for everything there is a way site I recommend to all lovers of unicycles
Review translated automatically
Reliable opinion
Zipp Neken 2 50cm3 2019 Installation of the carburetor very easy. Just screw two screws from the carburetor mount, put the throttle on the cable, screw the throttle. Install the air filter. Put on the fuel hose. Put on the manual suction line. I rate the installation of the carburetor as very easy even with no knowledge of mechanics. The carburetor after installation is pre-adjusted ready to drive. Recommended.
Review translated automatically
Reliable opinion
I own a motorcycle Romet Ogar 200.The fuel filter performs very well, it does not leak or let through the "garbage" that may be in the fuel tank. It fully fulfills its role.
Review translated automatically
Reliable opinion
Benzer shaft. When I opened the package, I was pleasantly surprised that the fender shines beautifully. There were no problems with installation, even my girlfriend could handle it
Review translated automatically
Reliable opinion
Zumico gr 500, capacity of the motorcycle 110cc, the fender fit perfectly, workmanship at the highest level, ABS material very good, looks super shiny.
Review translated automatically
Reliable opinion
Cylinder pin nuts and washers fmb139 super quality with attention to detail made of high quality materials I recommend to everyone
Review translated automatically
Reliable opinion
The screw does not differ from the original and was sold with the washer included where else you have to buy the washer separately I recommend the product
Review translated automatically
Reliable opinion
Product with a defect, badly laid varnish I am very disappointed, I trusted the company and paid in advance I am disappointed and disappointed
Review translated automatically
Reliable opinion
I recommend buying this universal fuel filter because it is well made and easy to install at this price it is probably the best fuel filter
Review translated automatically
Reliable opinion
Shaft seal18.9x30x5 4T 139 fmb very well made with attention to detail fits without any problem I recommend to everyone
Review translated automatically
Reliable opinion
Installation went without a problem threads not damaged the shipment itself also not damaged I recommend the product
Review translated automatically
Reliable opinion
The filter is good and there is nothing to complain about . It fulfills its role in Benzer Texsas 50 . I recommend !
Review translated automatically
Reliable opinion
i have a 2007 kingway 50 chopper I bought new starter chain sliders because the old ones were already very worn and while driving I could hear knocking after installing the new sliders the problem disappeared sliders fit perfectly in their place and not as I bought in another store nothing fit here, however, everything fit perfectly I am very pleased with them and I recommend them to anyone who wants to buy them.
Review translated automatically
Reliable opinion
The carburetor is of very good quality, it fits my Router ws 50 moped very well, the moped started to run faster and the combustion is not higher at all. Although I had to correct the alignment of the firing pin because it was choking but now everything is fine, and the carburetor itself was adjusted already after unpacking from the package. It is certainly better this Japanese carburetor than my old Chinese one. I highly recommend this product.
Review translated automatically
Reliable opinion
Hi!!I am the owner of a quad 150 atv for which I decided to purchase the above spark plug.The product is doing a great job,I have no reservations about it,you can really use it for a long time .The plug fits perfectly in the hole to the combustion chamber and gets the right temperature during the spark which allows you to keep the combustion chamber very clean.
Review translated automatically
Reliable opinion
Very simple ordering mechanism. This is the second time I have ordered this oil seal. The quality is convincing. The price/performance ratio is very good. I can only recommend this item. Intended use: Left crankshaft oil seal. Motorcycle: Ohvale GP-2 190 cc, Mini GP bike, year 2024
Review translated automatically
Reliable opinion
Hello. The materials I bought were matched to an old garden tractor engine. Everything was great. I was missing only full dimensioning for example pistons , rings, shaft. But this I understand because the parts are for specific engine Brands. After tel contact that the seller everything matched. Thank you Greetings and highly recommend.
Review translated automatically
Reliable opinion
Romet Ogar 202 50cc 4t 2017 carburetor bdb finally works, because the factory one was not workmanship and I put aside ,,finally does not muddle in 4th gear less heats up and can be adjusted I finally changed from pz16 to pz 20 japan and there is power I recommend 100% this store klijet service bdb I will buy only here anywhere else I highly recommend! ;)
Review translated automatically
Reliable opinion
Unfortunately I can not recommend this filter, because I got it with a defect, on the weld there was a very small invisible hole through which gasoline poured. I put the motorcycle together poured gasoline and here it dripped, and unfortunately it gave me a heap of work because I had to take everything back apart. But I'm not going to make an issue about a few zlotys.
Review translated automatically
Reliable opinion
I have a Zipp pro 50cc motorcycle from 2012 I ordered a starter shaft sealer and Motul 10w-40 semi-synthetic oil as for the sealer is very well made and thanks to this it can be installed quickly and without problems, oil clean and fragrant so you can confidently pour oil into the engine and enjoy the ride.
Review translated automatically
Reliable opinion
Zipp vz 50.2016.Previous vehicle kingway king, rode it 75,000km. The puller works well in its purpose. The screw could be sharpened which would not cause damage to the thread when removing the magnet wheel,but skillful application does not cause any problems.Regards Daniel.
Review translated automatically
Reliable opinion
Mega cool puller for 20 days I could not pull off the magnet wheel in the motorcycle KXD 125 I unscrewed the screw and then turned the puller and the wheel came off by itself there was no need to give so much pressure puller for the magnet wheel I recommend 10 out of 10 very durable cool design. I recommend :D
Review translated automatically
Reliable opinion
I run a repair store for single-track vehicles and sometimes I use Gmoto.pl, I am satisfied with the products offered in Gmoto.pl store, I recommend other users of single-track vehicles, parts offered by Gmoto are suitable for repairing single-track vehicles, the price is adequate to the quality.I recommend
Review translated automatically
Reliable opinion
Barton FR 50 2014. The pawl really does its job very well, the gears do not fall out or jump. the product is made very aesthetically pleasing and is very easy to install. I am very satisfied with this purchase, I recommend to other customers greetings warmly.
Review translated automatically
Reliable opinion
In the first words I want to convey that the ganik simply is very good under the capacity of 49 CCM The carburetor is very well adjusted, you just put it on and go enjoying every kilometer you drive. I am very satisfied with the purchase of this gasifier. Best regards.
Review translated automatically
Reliable opinion
This kit is very useful for overhauling FMB139 and related engines . Finally I have new screws, and do not have to look for anything . All that were scratched or machined I replaced with new ones . Now it is completely different . :D
Review translated automatically
Reliable opinion
As the only product I have a negative opinion because the quality of the thread in the nuts purchased was tragic both in terms of its appearance and the internal diameter on which the thread was made . I did not install them on the motorcycle .
Review translated automatically
Reliable opinion
Simple ordering process. The parts at a really fair price. Shipping costs fully ok. The parts exactly according to description and photos. I am very satisfied, many thanks for everything. Can only recommend the supplier.
Review translated automatically
Reliable opinion
I own a 2020 KDX Avenger 125cc quad and had a major problem with the ignition. The purchased spark igniter needed to be reworked, because the input did not fit on the pins. But it was done successfully, the quad runs like gold. I recommend the product.
Review translated automatically
Reliable opinion
Compliance with the description and everything as in the pictures. Everything is as it was supposed to be. Only the edges of the plastic do not look too good, not very aesthetically painted, but it is not visible after putting on the fender. I recommend
Review translated automatically
Reliable opinion
110ccm capacity quad from bemigermany with TZH152FMH engine (top starter) nothing in particular different from other Chinese 110 engines. The filter fits, does its job as it should, good product.
Review translated automatically
Reliable opinion
Barton Ranger 120CC, the bushing fits, of course. The oil bushing comes in a kpl. with a gasket-oring. I am very satisfied with the packaging of goods at Gmoto, I order a lot of small parts and not once was there a mistake :=)
Review translated automatically
Reliable opinion
The quality makes a very good impression. The look and fit are the same as the original part I replaced with it. Shipping was very fast, everything I ordered was securely packed.
Review translated automatically
Reliable opinion
Carburetor ok after adjustment perfectly goes into rotation cold smoke without suction, orginal nozzle is 78 one flaw is the drain screw from the float chamber is not drilled and you have to unscrew completely to drain petrol
Review translated automatically
Reliable opinion
KXD 607 so far made on him about 50 km on the road and a lot of hours on the tracks so far makes it, I judge what a very good and useful engine, although so soon will not get you know yourself where. Greetings
Review translated automatically
Reliable opinion
Favorable price. Product as described, sufficient for use even in the conditions of motorcycle service. A must-have item for any do-it-yourselfer who wants to remove the magnet wheel without problems.
Review translated automatically
Reliable opinion
The product is made of good quality material, which should give us better operation and prolong the life of the product. Replaced in Barton Volcano and there it fits better than the original. Aesthetically it looks respectable
Review translated automatically
Reliable opinion
Junak 901F 50cm3 capacityride it sensationally,and the products purchased from you emphasize the specific haracteristics of the motorcycle and increase its visual appearance from elegant to mega effectively nice
Review translated automatically
Reliable opinion
Hello everyone I own a Zipp pro 50 moped I ordered a 72cc cylinder head gasket, it was a perfect fit and went around without any modifications. I rate the product as very good.
Review translated automatically
Reliable opinion
The clutch tappet simmerring could enter the socket with a little more resistance. Completely smooth on the outside wall makes it easy for it to fall out when the clutch is manipulated more sharply.
Review translated automatically
Reliable opinion