Motorcycle parts
Kawasaki Z 750 - Page 5

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-11-12, 15:59

View original

Krzysztof

Honda Africa Twin XRV 750 1999. The piston fits the calipers on older models, the pistons for my motorcycle are 3mm shorter. I ordered the set with the idea of shortening it. The material turned out to be soft compared to the original(this does not prove its strength, therefore the rating of 3 from the quality), cutting 3mm on the lathe did not overheat the pad and after protecting it on the turning side with an appropriate specific will ensure that it will not lose its anti-corrosion properties. A perfect replacement for the twice more expensive original. The width agrees, the quality of the seals seems to be OK, after installation it does its job - I recommend.

Review translated automatically

Reliable opinion

2021-02-02, 22:02

View original

Daniel

99r Honda VFR 800 FI RC46. Simple quick installation. Filter adapted for an ordinary ring wrench. Uses k&n products great look and performance. I recommend

Review translated automatically

Reliable opinion

2019-03-10, 10:47

View original

Mirosław

Kawasaki Z900. The filter is better made than the original. Very good ease of installation,I am 100% satisfied and recommend to everyone.

Review translated automatically

Reliable opinion

2024-09-20, 12:04

View original

Aurélien

Used for a complete rebuild of my caliper, the piston is the same as the original. I recommend

Review translated automatically

Reliable opinion

2021-10-08, 12:10

View original

Artur

There is nothing to say about Hiflo and the quality of their products, so I usually choose their filters.

Review translated automatically

Reliable opinion

2022-03-31, 10:27

View original

Dariusz

Fitting filter for Kawasaki versys KLE 650 , the advantage of it is that it has a key cap .it is ok

Review translated automatically

Reliable opinion

2021-06-22, 08:54

View original

Sylwek

The filter of a very decent brand. I buy it all the time and have never been disappointed. A very big plus is that it can be unscrewed with a socket wrench. If someone has little space, as I do, to do anything at the filter then such a head on the filter is salvation. It is a little more expensive than the standard version but worth every penny. Last time I had a regular filter I had to perforate it and pour oil in the exhaust pipes to unscrew it , in this case the replacement was clean, fast and above all simple! I recommend

Review translated automatically

Reliable opinion

2017-04-07, 10:56

View original

Bartłomiej

DID chains, as you know, have an excellent reputation among motorcyclists. Not without reason. Excellent quality and durability. This model perfectly supports motorcycles with power reaching well over 100 hp. Its durability is perfectly evidenced by the fact that I had to get a new, better cupping machine to install it. The current one gave up. The chain is extremely durable. I recommend it to everyone!

Review translated automatically

Reliable opinion

2021-06-29, 10:25

View original

Leszek

Honda XL 600 V Transalp. A filter like a filter, it's hard to judge it by eye. It screwed in easily and pleasantly. All indications are that it filters as God has commanded. Shouldn't there be an o-ring in the place where it is screwed onto the spigot protruding from the block? I can't hide the fact that I would be happy to win four hundred bucks because I need a clutch and cash is tight.

Review translated automatically

Reliable opinion

2023-05-24, 21:04

View original

Dariusz

very good product,easy to install,app to download,connects to your phone via blue tooth and you have everything on the screen of your phone,like charging current,battery condition,monitoring its performance and so on,very useful thing,highly recommend in good conscience

Review translated automatically

Reliable opinion

2022-01-18, 10:25

View original

Matecki

Suzuki RM 250 1993.The products ordered from you always match the description, so the installation goes smoothly because everything is matched to the right motorcycle.I am satisfied with the cooperation with Gmoto. It is not the first year we have worked together and I rate the company and the website at 5. Best regards Matecki.

Review translated automatically

Reliable opinion

2025-05-06, 07:08

View original

Fabian

I love the K&N oil filters. Most people screw them on with an open-end wrench and are surprised when they start leaking. Tighten them by hand and remove them again with the open-end wrench. Never had any problems. Only good experiences.

Review translated automatically

Reliable opinion

2016-03-18, 21:30

View original

Rafał

Honda Shadow VT 750 Black Spirit RC48 2003. The filter compared to the previous one I had installed has a nut, which makes it much easier to install /remove the filter, in the absence of a special key for installation. Definitely a plus.

Review translated automatically

Reliable opinion

2024-05-05, 17:43

View original

Wiesław

Filter as described hassle-free installation and a big plus for the ability to tighten with a wrench without using special wrenches for filters. Painting without cavities, and it looks aesthetically pleasing. Plus for the protective film on the filter inlet.

Review translated automatically

Reliable opinion

2024-09-20, 06:30

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2024-10-28, 10:55

View original

Artur

The most important thing is that they fit kawasaki vn 800 classic. I will not write anything more because I just put on and about their quality I will find out during the use of the motorcycle. But at first glance you can see that decent bearings.

Review translated automatically

Reliable opinion

2023-05-29, 13:07

View original

Mariusz

When it comes to oil filtration in our motorcycles, K&N is simply in a class of its own. I've been using them forever and although it's just a filter I can't imagine another one in my machine. I recommend.

Review translated automatically

Reliable opinion

2022-01-18, 20:35

View original

Sławomir

Filter hiflo 303 RC, standard height, throughput to be evaluated, as I wear it out I'll see if the only difference is the key cap on the body, although at first glance it looks similar. We'll see.

Review translated automatically

Reliable opinion

2021-01-24, 16:53

View original

Bogdan

I own a motorcycle honda CBR 1000F, vintage 1966, capacity 1000 cm. This is another filter from this manufacturer that I bought, and I have never had any problems with them have always served their purpose.

Review translated automatically

Reliable opinion

2022-01-11, 15:35

View original

Wojciech

XL 600VA 1987 Oil easy to use does not require instructions. I recommend this product. Very good quality product for its price. Quick delivery hassle-free service. I recommend

Review translated automatically

Reliable opinion

2019-12-27, 13:32

View original

Mariusz

Honda Shadow VT 600 1994. The kit includes all the gaskets that need to be replaced when reconditioning the brake caliper, plus grease for the piston. Everything fit as in the original.

Review translated automatically

Reliable opinion

2025-03-01, 08:08

View original

HOCMERT

20/20 The product corresponds to 100% of my expectations, my entire order was carefully packaged and delivery was very fast. You can order with your eyes closed.

Review translated automatically

Reliable opinion

2020-05-03, 09:14

View original

Kamil

Kawasaki z750 - 2007 year. Product quality definitely at a good level. Dimensions, fit as much as OK. Finally the annoying "ticking" from around the collector disappeared :)

Review translated automatically

Reliable opinion

2021-03-20, 11:29

View original

Bartosz

The motorcycle is a Honda Transalp XL 600 The piston holds the dimension perfectly in every plane. The only difference is the different shape of the bottom of the piston, but this does not seem to affect the operation.

Review translated automatically

Reliable opinion

2019-01-14, 11:45

View original

Łukasz

Hello, The filter I purchased meets my expectations. Easier to install than standard filters. I am very satisfied and recommend, Greetings

Review translated automatically

Reliable opinion

2019-06-10, 20:27

View original

Wojciech

Fits perfectly, should be added to the oil refinisher, the cost is pennies and most often the protection is already affected by corrosion and suitable for replacement

Review translated automatically

Reliable opinion

2018-03-05, 18:27

View original

MARCIN

Hello, I bought this filter for oil change in my motorcycle i.e. 2006 Yamaha Stratoliner 1900. I have been using this product for about 5 years and am satisfied with it.

Review translated automatically

Reliable opinion

2024-09-24, 06:41

View original

Tomasz

The filter performs its function perfectly, after pouring off the old oil you can not see any flecks, etc. Thanks to the flexible gasket, I tighten it by hand and nothing leaks.

Review translated automatically

Reliable opinion

2021-07-25, 10:42

View original

Karol

Kawasaki KX 91r good workmanship simple installation without any problems it was hard to find sealers is such an old motorcycle but these fit perfectly. I recommend.

Review translated automatically

Reliable opinion

2021-12-12, 20:14

View original

Kordian

I always buy filters from HIflo and this time, too, everything fits until nice. I recommend to trust this brand as much as possible. Gmoto as usual at a high level. XJ600

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2020-04-20, 09:38

View original

Adrian

Honda CB600 F Hornet, thanks to the possibility of using a ring wrench, the replacement went remarkably fast , it is worth paying a few zlotys extra for this convenience

Review translated automatically

Reliable opinion

2024-07-05, 06:46

View original

Krzysztof

Great quality replacement, the previous protection totally corroded, I hope this will live a little. I replaced it on a DR 650 SE vintage 1996

Review translated automatically

Reliable opinion

2020-06-01, 17:53

View original

mariusz

yamaha diversion 600 2002 element purchased really good quality,without any problems installed in the shin of the front suspension recommend kind regards lwg

Review translated automatically

Reliable opinion

2025-06-17, 11:39

View original

Thomas

Everything is fine! Battery was quickly filled and ready for use. How long it will last remains to be seen, but so far there have been no problems

Review translated automatically

Reliable opinion

2020-04-26, 21:15

View original

Marcin

Fits perfectly on my old venerable XJtek, from 96. No problems with threads or leakage from under the filter gasket. I highly recommend the product.

Review translated automatically

Reliable opinion

2025-06-17, 11:40

View original

Thomas

It fits and is tight so far! Unfortunately, I can't say any more about this, as it will only become clear at the next oil change/oil filter replacement

Review translated automatically

Reliable opinion

2020-06-08, 10:06

View original

Łukasz

I am satisfied everything efficiently and according to what I ordered. The ordered goods meet my expectations. I positively evaluate this store.

Review translated automatically

Reliable opinion

2021-07-12, 13:48

View original

Rafał

Assembled for the 2015 Kawasaki ER-6N. The filter fits well, works well for daily and more sporty riding. Worth the price.

Review translated automatically

Reliable opinion