Forgot password
Order status
Free delivery from 150 euro
Motorcycle parts
M72 750
Manufacturer
Price
Sort
Options +2 
Browse by manufacturer
Products reviews
I own a K750 motorcycle, with an engine capacity of 750cm, manufactured in 1961. I am in the process of carrying out a major overhaul, the purchased handles fit perfectly, no problems with installation, overall I am satisfied with the product. This is not the first product bought from Gmot, previous products were o.k. too. I recommend the store, professional service, ordered goods promptly shipped, I recommend the store.
Review translated automatically
Reliable opinion
I own a motorcycle Dniepr 650 1978r production. The quality of the products and their actual condition,fit fit perfectly without any modifications. I buy all parts for this motorcycle at Gmoto.pl
Review translated automatically
Reliable opinion
The shaft makes a very good visual impression. The connecting rods are copper-plated, as is otherwise only known from the legendary Hoeckle shafts. The connecting rod bearings are absolutely free of play, the concentricity has a deviation of less than one hundredth, which can be seen as a measurement tolerance, and the offset when measuring the rollover is also barely measurable. The bearing seats at the front and rear are 1-2 hundredths below dimension, which makes it easier to fit the shaft. However, a drop of Loctite should be used to be on the safe side. I noticed the M6 countersunk screws with cross recess, which I replaced with hexagon socket screws with 10.9 strength as a precaution.
Review translated automatically
Reliable opinion
Item received in good condition. There are some quality problems. Buttom surface is not flat, and gasoline leaks on the ground beacuse the gasket cannot seat. Buttom drain screw only has a filter mesh one one of the carburettors?! They forgot to put it on? The needles, both on float and main needle are not the same lenght! They differ by several mm and will not ajust the same way! overall bad quality control and finish. Be awarre also the floats are made from plastic and not very durable. cannot recomend this product.
Review translated automatically
Reliable opinion
Very good quality and price. This review applies to all the parts ordered and received. I will continue to order from you. If I had known that this kind of ordering was available, I would have used it in the past when restoring old motics.
Review translated automatically
Reliable opinion
Rubber itself well made, but I do not recommend giving on the kopnak from derbi senda because you have to trim it, at first it holds, but when a longer time will be in use it can start to fall off the kicker
Review translated automatically
Reliable opinion
Very good product .Price quality wonderful ratio already fitted it into the engine everything fits hope it works long time.Not enough stock bought the last one.
Review translated automatically
Reliable opinion
Very good quality workmanship fits the crankshaft wonderfully , never found this part anywhere before and the price is very good.
Review translated automatically
Reliable opinion
The shaft is wonderful. Tested and tried by me in other engines. The product is for 6c. The bike is a 1945 M72.
Review translated automatically
Reliable opinion