Forgot password
Order status
Free delivery from 150 euro
Motorcycle parts
Simson S70 E 4-biegowy 1986 - Page 2
Manufacturer
Price
Sort
€4.79
Simson coil cap
€9.98
Simson chain guard
€4.63
Gear 13z 1/2x5.4 Simson
€2.16
Simson wheel hub bushing
€1.14
Simson air filter spring
€49.59
Lowest price from 30 days before discount: €66.13
Right fork lag Simson S50 S51 S70 SR50 SR80
€3.57
Pad 32x42x0.3 Simson
Options +1 Podobne:
€4.80
Lowest price from 30 days before discount: €5.05
Athena piston pin bearing 12x16x15.8 - MNB120160158A
from 2
Browse by manufacturer
Products reviews
The screw is made with precision. I just pay attention to the assembly! The original screw is at least twice as long. The torque recommended in the service book (43Nm) is far too much for a Yamaha Thundercat, fekt is a broken thread.
Review translated automatically
Reliable opinion
Professionally made instrument, a must have for every DIY enthusiast as well as a professional for the garage.
Review translated automatically
Reliable opinion
The product is very similar to the original. The only fault is that the threaded end is too short compared to the original. It's missing about 5 to 8 mm. This damaged the threads on my housing. I had to dismantle everything and redo the threading with ilsert.
Review translated automatically
Reliable opinion
I have always dreamed of something like this. Finally I could clean the nozzles thoroughly. amol the tips are so sharp that even if you try, you can enlarge the hole in the nozzle to a given size. So not only cleans, but if you want to enlarge the holes. I recommend 100%
Review translated automatically
Reliable opinion
The carburetor managed to install perfectly in the simson, the quality is very good (it is not the usual Chinese). Very helpful is the installation instructions in Polish included with the carburetor. so far it works flawlessly.
Review translated automatically
Reliable opinion
Yamaha XVS 1300 CU year 2014 The bolt is shorter than the original and does not hold the size of the original bolt. It should not be indicated to fit this model. The only use for it is a copper gasket.
Review translated automatically
Reliable opinion
Good quality gasket. Fits the Simson and does the job. Quality and flexibility on the plus side. There is no tendency to break.
Review translated automatically
Reliable opinion
For carburetor 16 N3 Simson SR 50 fit. Complete with washers and nuts. Good workmanship, simple, everything ok.
Review translated automatically
Reliable opinion
Simson s51 enduro 50cm3 year 1987 product very solidly made, the quality of the plastic is very high. recommend.
Review translated automatically
Reliable opinion