Motorcycle parts
Suzuki GSX 1400 - Page 6
Manufacturer
Price
Sort

€247.91
Lowest price from 30 days before discount: €260.95
delivery 0 €TRW Lucas MSW 223 RAC front brake disc - MSW223RAC

€221.10
Lowest price from 30 days before discount: €232.74
delivery 0 €TRW Lucas MSW 223 front brake disc - MSW223

€9.40
Lowest price from 30 days before discount: €9.89
HifloFiltro HF 138 RC Racing oil filter - HF138RC

€93.98
Lowest price from 30 days before discount: €104.43
DID timing chain SCA0412ASV-156 open timing chain with lugs

€5.98
Lowest price from 30 days before discount: €6.29
HifloFiltro HF 975 Suzuki oil filter - HF975

€8.62
Lowest price from 30 days before discount: €9.07
Athena 45x50x30 connecting exhaust gasket - S410210012032

€10.74
Lowest price from 30 days before discount: €11.31
Athena 43x49x20 connecting exhaust gasket - S410510012055

€13.27
Lowest price from 30 days before discount: €13.97
Athena 45x51x20 connecting exhaust gasket - S410510012056

€12.83
Lowest price from 30 days before discount: €13.50
Athena connecting exhaust gasket 38x42x30 - S410510012051

€2.92
Lowest price from 30 days before discount: €3.08
Athena 33x41.5x5.3 exhaust manifold gasket - S410510012007


€156.13
Lowest price from 30 days before discount: €173.48
delivery 0 €DID 530 ZVMX 116 X-ring S&S open drive chain with cap silver


€74.86
Lowest price from 30 days before discount: €83.18
DID 530 NZ 116 open drive chain with fastener


€19.87
Lowest price from 30 days before discount: €20.92
Athena 46x58.1x10.5 front suspension seal set - P40FORK455116
Products reviews
2018-11-01, 20:15
Krzysztof
I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2018-03-18, 13:50
Rybson
Suzuki GSR 600 - 2007 This is the first time I purchased an oil filter from K&N, previously I used hiflo. I suggested reviews but was convinced by a video comparing the inside of the filter It's nice that there is a "nut" as standard, which will certainly make it easier to unscrew at the next replacement We'll see after the season if it was worth paying the extra few zlotys
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2019-03-31, 12:52
Michał
The GS 500 motorcycle is a machine that I use every day. It gets no concessionary fare and has to endure all sorts of roads. Sometimes fast riding on the expressway, sometimes touring on rough and bumpy roads. The result of this effort is a broken head frame bearing, which bravely endured all the forces acting on the motorcycle. It was time for a bearing from the proven Tourmax company, which I got very quickly thanks to the Gmoto.pl store. The package came quickly, well packed. Goods of the highest quality. Since the replacement of the bearing nothing has happened to the motorcycle and you can confidently continue the season.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-05-15, 21:39
Wiesław
Suzuki GSX-R 1100 motorcycle from 1987 . Due to its age I decided to replace the front master cylinder , searching through the offers I came across a repair kit at gmoto.pl and decided to purchase it along with the brake lever that works with the piston and may have been worn out . The parts after unpacking turned out to be not different in appearance and quality from the original with the included box of special grease . With the assembly there was no problem . All parts fit and work as intended .
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2021-04-19, 21:18
Bartłomiej
I took apart the motorcycle a little more, and when I removed the intake ducts into which the carburetor enters it turned out that the old gaskets did not hold, you could see blowouts on the head (as if the fire from the chamber was coming back), well after replacing with new gaskets there is no problem adjusting the carburetor.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-11-04, 10:28
Patryk
I own a 2003 Suzuki DL 1000 motorcycle. Reperature of the front brake master cylinder I needed because it began to leak and go hard. The replacement is not difficult and the parts fit well. Even without instructions there are no problems to assemble everything correctly ;)
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-07-11, 09:59
Mariusz
I am a happy owner of a yamaha yzf 125r in which I recently noticed oil loss , I replaced the valve seals which I ordered from gmoto and I am very satisfied , solidly made . Easy to install and fit to my 2010r model I recommend to everyone.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-07-11, 09:59
Mariusz
I am a happy owner of a yamaha yzf 125r in which I recently noticed oil loss , I replaced the valve seals which I ordered from gmoto and I am very satisfied , solidly made . Easy to install and fit to my 2010r modelj recommend to everyone.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2018-03-23, 07:30
Krzysztof
A solid, branded filter, for reasonable money. K&N filters use both in the car and motorcycle, I have never yet been disappointed with this brand. For the engine it provides safety and comfort, and for the owner - holy peace of mind. I sincerely recommend.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2024-02-27, 13:14
Radoslaw
Voltage regulator made of good materials, fits perfectly and also perfectly performs its function. I have been using it for some time now, it works flawlessly, so I can confidently and in good conscience recommend it to others who are interested. I really recommend it.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2024-05-17, 13:20
Jakub
The first time I pulled such a filter with a socket - a fantastic thing. It goes smoothly and with any wrench pulls the filter - I immediately bought the same. Hiflo brand used with me for several seasons - zero problems with installation or removal.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2024-05-10, 11:32
Paweł
The gasket as described, perfectly fits the selected motorcycle. It could not have been otherwise thanks to the simple and intuitive cataloging of products by model and vintage. The goods arrived one day earlier than the date specified during the purchase.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2024-07-05, 07:20
Wojciech
K&N even if hidden under the collectors, improves the mood. It's like with Ray ban glasses others also darken, but it's not the same;) The filter works, fulfills its role and in addition improves the mood of the owner ;) Greetings
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2021-02-09, 10:48
Marcin
Seemingly just a pin however, it allows even a 20 year old motorcycle to retain its original appearance. They do not differ in appearance and quality at all from those originally used for the installation of fairings in my 2000 Hayabusa.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2022-01-27, 10:50
Sławomir
The pins fit the rump (including the plastic filling for the tail lamp) on the Suzuki SV650n K8. They perfectly replace the lost originals - there is no play, they do not fall out and do not break in the hands.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2022-03-10, 17:15
Kamil
Very cool idea with the possibility of unscrewing with an ordinary wrench , not all filters have such a possibility , in some motorcycles it makes the replacement very easy .I recommend !!!
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion