Motorcycle parts
Yamaha XJR 1300 - Page 9

2021-11-06, 14:50

View original

Radosław

Yamaha fz1 2008r I purchased a front sprocket one tooth smaller than the original, that is, from 17 teeth to 16.By such a replacement, the motorcycle has become much more dynamic better acceleration already in the lower range of revs.Czc ordered at gmoto.pl made very well fit perfectly.

Review translated automatically

Reliable opinion

2020-08-03, 18:02

View original

Rogério

I got an yamaha xt350 of 1991. I am very glad with this item. Very good quality / price. Recomend it.

Review translated automatically

Reliable opinion

2020-03-01, 11:24

View original

Mateusz

Replacement with JMP plates helped, I used them in the Triumph Rocket III as to the quality I can only say after a longer use so far everything is ok and from the appearance and external treatment looks good probably I would know more if I measured it with a micrometer screw and for example hardness but I did not do this only after putting it on I measured the valve clearances again and checked that they met my initial assumptions . After replacement the motorcycle again runs quietly and ignites without any problem on the shot greetings

Review translated automatically

Reliable opinion

2024-08-26, 21:39

View original

Bartłomiej Świątek

For the xj900 s Diversion 1996 model, the bearings fit at a glance. The motorcycle was assembled with this bearing. There has not been a test ride yet, but the handlebars on the jack work fine. The only drawback is that the race of the upper bearing protrudes slightly from the seat, but this should not cause a problem because there is a factory cover that covers the entire bearing.

Review translated automatically

Reliable opinion

2021-11-08, 16:16

View original

Kamilla

Yamaha Virago 1100 year 1996 Product as ordered. In the original box. Assembly without adventures. Everything fit. Parameters of the device in accordance with the manufacturer of the motorcycle.

Review translated automatically

Reliable opinion

2020-05-09, 06:18

View original

Marek

Yamaha XV 1100, year 1996, the sensor did its job and the installation process went smoothly, my XV regained its former efficiency

Review translated automatically

Reliable opinion

2020-03-23, 17:25

View original

Tadeusz

I own a hd sportster 1200 89r. The chain meets my expectations. B.good quality at a low price . I recommend

Review translated automatically

Reliable opinion

2020-03-23, 17:25

View original

Tadeusz

I own a hd sportster 1200 89r. The chain meets my expectations. B.good quality at a low price . I recommend

Review translated automatically

Reliable opinion

2024-10-27, 11:39

View original

Sabrina

It looks better than the original. It is worth leaving the original washer then the bottom of the nut will be flush with the shelf

Review translated automatically

Reliable opinion

2022-05-14, 10:57

View original

Tomasz

Hi I own a motorcycle Honda CB 1000 R- 2009 R I recommend all K&N products super quality.

Review translated automatically

Reliable opinion