Motorcycle suspension - Front
Honda VT 500 E 1985

2020-02-25, 22:28

View original

Johan

Used for Honda FT 500 1983. Fitted within the hour (after disassembly & preparation = removal of old bearings). Have used 50 mm pvc pipe to drive bottom cup in; tightness of fit was as it should be. Did not use the supplied washer but made my own of 30x36x3 mm so the original rubber seal could sit below the (inner part of) the bearing. Re-used the original bottom washer (0.8 mm thick) to shield the seal. The (upper) adjustment nut also carries a thin shield. I had to grind the spigot (for the shield, on the nut) to a chamfer, as it just touched the radius of the upper bearing inner ring. On the 3rd picture, where the shield lies under the nut: red arrows = grind inner dia of spigot, shield fits at outer dia (on top as depicted). Ordered a 2nd set for my Honda XBR 500.

Review translated automatically

Reliable opinion

2020-04-20, 11:27

View original

Adrian

Hi Honda Cbr 250r 2011 year The seals fit perfectly . Workmanship is very good , they look really decent despite the fact that they cost half as much as the competition. When applying to the shaft also no problems and damage (which often happens with poor quality product). After mounting they perform their function very well. I recommend and greetings

Review translated automatically

Reliable opinion

2017-10-13, 18:24

View original

Wojciech

honda vf 500 magna,goods in line with my expectations, seals fit perfectly, no residual rubber, etc as happens with other zimer, plus for the solid plastic packaging

Review translated automatically

Reliable opinion

2020-02-19, 18:44

View original

Dariusz

Sealers made of very good material are also very tight and flexible which makes it easy to install when replacing old sealers . I recommend

Review translated automatically

Reliable opinion

2025-10-14, 11:40

View original

salmon Sébastien

The equipment is exactly as described. Very good value for money. Delivery was very fast. Site to recommend

Review translated automatically

Reliable opinion

2021-02-03, 22:45

View original

Michał

Cross Honda CR80r from 2000 year gaskets perfectly do their job, visually as well as material product very good quality.

Review translated automatically

Reliable opinion

2022-07-26, 09:01

View original

Romuald

Sealers of super quality, fit 100%. Highly recommend. Installed and the lags already dry. and the motorcycle is in working order :)

Review translated automatically

Reliable opinion

2017-06-24, 14:58

View original

Adrian

KAWASAKI ER 5 2001 They fit and look solid made, mounting them were very simple with good material

Review translated automatically

Reliable opinion