Motorcycle tools W55
WSK 175

2022-04-27, 23:16

View original

Adamsky73

WSK M06 B3 1979. The puller made exemplary. So far it has been used for two WSK engines and has performed sensationally. This tool is indispensable in small as well as large workshops.

Review translated automatically

Reliable opinion

2021-03-21, 23:40

View original

Bartłomiej

The puller is made of good quality thick sheet metal, which certainly will not bend after several uses. All the holes matched, with this puller I unbolted the engine in a WSK 125 much faster than with a classic hammer and chisel. The only minor flaw I noticed was a rather large burr with which I cut myself, but a moment on the grinder and the problem was over. I highly recommend it to all WSKe owners.

Review translated automatically

Reliable opinion

2020-08-24, 13:57

View original

Sebastian

The idea for the puller and the drilling of some of the holes was excellent, unfortunately the execution is average - some of the holes need to be drilled so that the screw "six" can pass through, to make matters worse the accuracy of the holes is "so-so" - they could be made more accurate by at least 5 mm. Thus, a second revision of this puller would be useful.

Review translated automatically

Reliable opinion

2021-10-06, 08:34

View original

Łukasz

I bought the parts for my WFM 125 M06 from 1954 first models engine . Workmanship ok, but I had to drill one hole to fit into the holes in the crankcase. Express shipping , I received the parts on the second day. I recommend

Review translated automatically

Reliable opinion