Forgot password
Order status
Free delivery from 150 euro
Product ID: 63507
Rear sprocket rubber - 63507
€4.24 including VAT
We keep up with your passion!
Delivery tailored to your needs
You have 15 days to make a decision
New rear sprocket carrier for Chinese motorcycles and 4T mopeds
| Manufacturer: | Kengo |
|---|---|
| Manufacturer id: | 63507 |
| Guarantee: | 12 |
- made of high-quality rubber resistant to abrasion, temperature and petroleum derivatives
- thickness: 14 mm
- total diameter: 134 mm
- center hole diameter: 45 mm
Gmoto.pl Paweł Cebulak, Tadeusza Kościuszki 78, 37-100, Łańcut, PL, [email protected]
Fits to
Product reviews
5
4
3
2
1
-
Goods well packed by the manufacturer. Fits very well and is of matching material. The part has lasted about 6000 km on the bike.
Review translated automatically
Reliable opinion
-
-
Bardzo dobry produkty , Polecam wszystkim bo warto.
Review translated automatically
Reliable opinion
-
-
Cóż tu powiedzieć guma spełnia swoją rolę i robi co powinna za tą cenę sądzę że jest dobrze wykonana ^^
Review translated automatically
Reliable opinion
-
-
The product fits. Compared to the original it feels a little softer. There was a little play after putting the wheel on, but against the damaged pulled original it is incomparably better.
Review translated automatically
Reliable opinion
-
-
With sharper driving it does not pass the test so it can be
Review translated automatically
Reliable opinion
-
-
I bought this sprocket for zipp, it came mega fast, contact with the seller at the highest level. Quality of materials very good, fit 100%, aesthetics I rate very good with a big plus
Review translated automatically
Reliable opinion
-
-
Hello, I have a tuned 50/175 cc motorcycle that has a gear on this rubber. This rubber for the rear sprocket drove me 8 thousand kilometers on the engine 50 and 110 cc. Without problems therefore I recommend. I write a note for all DIY enthusiasts like me that if you give a large and powerful engine to such a small motorcycle, the rubber will need to be replaced every 1-2 months. Rubber is hard and good, but up to 11 horses maximum At 18 horses the rubber can not cope I rate 5
Review translated automatically
Reliable opinion
-
-
Product made solidly, fits perfectly on Benzer Shaft recommend. NO problems with fit and installation.
Review translated automatically
Reliable opinion
-
-
Vehicle: Zumico GR 500 The ordered part fit perfectly, easy to replace, made of very good materials.
Review translated automatically
Reliable opinion
-
-
Gb Street 72 When I was replacing the drivetrain on my moto when removing the rear wheel literally spilled out this rubber taker , the pieces were so many that I was not able to pick them up and at least put them together . The part I ordered here fit perfectly and was made of better quality materials than the original . In general, I ordered here a lot of parts and can hand on heart recommend this store . Greetings
Review translated automatically
Reliable opinion
-
-
Rear sprocket rubber made of very durable rubber that perfectly fits the rear wheel as well as the rear sprocket sand! Very good quality product I recommend !
Review translated automatically
Reliable opinion
-
-
Benzer shaft fits perfectly :) I recommend the purchase of this product, I think it can be used on most mopeds without fear
Review translated automatically
Reliable opinion
-
-
I can't write much because I'm just about to get started on the repair but I'm very happy with my purchase the goods look solid and good . I recommend a solid seller .
Review translated automatically
Reliable opinion
-
-
For gb street yamasaki fits 100% recommend . Replacement of this rubber gives a lot. I recommend both this product and this store.
Review translated automatically
Reliable opinion
-
-
Product as described, fits perfectly, very professional and fast service. I highly recommend.
Review translated automatically
Reliable opinion
-
-
The zebra rubber for Reuter ws 50 fits the motorcycle. Product approx.
Review translated automatically
Reliable opinion
-
-
Barton Fighter 4t 50 The rubber fits perfectly, I hope it will also last a long time. The rubber gives the impression of being reinforced Very fast delivery I recommend to everyone.
Review translated automatically
Reliable opinion
-
-
Yamasaki ym50-8 2011r Fits, the wheel is stiff, for the thickness is a little thinner than the original
Review translated automatically
Reliable opinion
-
-
Barton fighter 72 4t. After putting it on, the momentum improved. Very durable product, recommend
Review translated automatically
Reliable opinion
-
-
Everything fell into place.I recommend
Review translated automatically
Reliable opinion
-
-
I recommend it is very good
Review translated automatically
Reliable opinion
-
-
Router WS50-Fits perfectly
Review translated automatically
Reliable opinion
-
-
product ok-fast delivery
Review translated automatically
Reliable opinion
-
-
product ok-fast delivery
Review translated automatically
Reliable opinion
-
-
2012 Benzer Yankee 4T
Review translated automatically
Reliable opinion
-
-
kingway naked 125
Review translated automatically
Reliable opinion
-
-
It is fitted,OK
Review translated automatically
Reliable opinion
-
-
GB Street 50cm3
Review translated automatically
Reliable opinion
-
-
romet zetka 50
Review translated automatically
Reliable opinion
-
-
Romet K125
Review translated automatically
Reliable opinion
-
-
recommend
Review translated automatically
Reliable opinion
-
-
recommend
Review translated automatically
Reliable opinion
-
-
recommend
Review translated automatically
Reliable opinion
-
-
Everything is fine, I recommend.
Review translated automatically
Reliable opinion
-
-
highly recommend!!!
Review translated automatically
Reliable opinion
-
Questions & Answers
Have a question about this product?
No one has asked a question about this product yet. Be the first and get an answer from our community or experts!
