Motorcycle suspension - parts
Yamaha BT 1100 Bulldog 2006

2021-02-16, 11:19

View original

Oleksandr

I have a Yamaha XJR 1300 motorcycle and needed sealers and hoods for the lags. The hoods in the front suspension were still original and I just wanted the look to stay the same. Because of this and I bought this kit. And plus it turned out to be a good quality product. Hoods and sealers quite flexible and fit perfectly in their places. I am very satisfied. I recommend.

Reliable opinion

2024-08-26, 21:39

View original

Bartłomiej Świątek

For the xj900 s Diversion 1996 model, the bearings fit at a glance. The motorcycle was assembled with this bearing. There has not been a test ride yet, but the handlebars on the jack work fine. The only drawback is that the race of the upper bearing protrudes slightly from the seat, but this should not cause a problem because there is a factory cover that covers the entire bearing.

Reliable opinion

2024-05-03, 05:35

View original

DAWID

Exemplary fit head tube bearings. They have an additional seal, which will distinguish them from other bearings. Once installed, they fulfill their purpose 100%. Recommended.

Reliable opinion

2024-10-27, 11:39

View original

Sabrina

It looks better than the original. It is worth leaving the original washer then the bottom of the nut will be flush with the shelf

Reliable opinion