Motorcycle suspension - parts
Yamaha XJR 1300 C 2016

2021-02-16, 11:19

View original

Oleksandr

I have a Yamaha XJR 1300 motorcycle and needed sealers and hoods for the lags. The hoods in the front suspension were still original and I just wanted the look to stay the same. Because of this and I bought this kit. And plus it turned out to be a good quality product. Hoods and sealers quite flexible and fit perfectly in their places. I am very satisfied. I recommend.

Review translated automatically

Reliable opinion

2024-08-26, 21:39

View original

Bartłomiej Świątek

For the xj900 s Diversion 1996 model, the bearings fit at a glance. The motorcycle was assembled with this bearing. There has not been a test ride yet, but the handlebars on the jack work fine. The only drawback is that the race of the upper bearing protrudes slightly from the seat, but this should not cause a problem because there is a factory cover that covers the entire bearing.

Review translated automatically

Reliable opinion

2024-05-03, 05:35

View original

DAWID

Exemplary fit head tube bearings. They have an additional seal, which will distinguish them from other bearings. Once installed, they fulfill their purpose 100%. Recommended.

Review translated automatically

Reliable opinion

2019-06-10, 20:27

View original

Wojciech

Fits perfectly, should be added to the oil refinisher, the cost is pennies and most often the protection is already affected by corrosion and suitable for replacement

Review translated automatically

Reliable opinion

2024-07-05, 06:46

View original

Krzysztof

Great quality replacement, the previous protection totally corroded, I hope this will live a little. I replaced it on a DR 650 SE vintage 1996

Review translated automatically

Reliable opinion

2020-06-01, 17:53

View original

mariusz

yamaha diversion 600 2002 element purchased really good quality,without any problems installed in the shin of the front suspension recommend kind regards lwg

Review translated automatically

Reliable opinion

2020-11-07, 21:27

View original

Robert

Yamaha xvz12TD. Everything fits. The old ones unfortunately corroded. Thank you. I will definitely come back to you.

Review translated automatically

Reliable opinion

2024-10-27, 11:39

View original

Sabrina

It looks better than the original. It is worth leaving the original washer then the bottom of the nut will be flush with the shelf

Review translated automatically

Reliable opinion

2018-03-05, 19:36

View original

Dariusz

Yamaha Drag Star 1100 2007 year super stuff recommend !!!!!!!!!!!!!!!!

Review translated automatically

Reliable opinion

2016-03-02, 02:45

View original

Sławomir

Yamaha XTZ 660 Tenere 3yf,1994

Review translated automatically

Reliable opinion