Motorcycle carburetor floats
WSK 125

2021-08-02, 09:45

View original

Damian

The float looks decent, but the needle is too short for the G20M carburetor. Float sinker, does not allow the needle to reach the end. (It is possible that only I got such a copy). I compared it with several floats and it is definitely shorter.

Review translated automatically

Reliable opinion

2020-08-03, 10:05

View original

Hubert

The float was made on average. The weld was made quite carelessly, with so-called bobbles which caused the float to jam in the float chamber, but a little sandpaper took care of the problem. The float does its job on a 1973 wsk 125 b3.

Review translated automatically

Reliable opinion

2015-11-29, 19:14

View original

Wiktor

An indispensable piece of replacement equipment for further trips as well as the home workshop. Part of good quality. Recommended. More about replacement equipment for distant travel at: http://125cmmieszanychuczuc.blogspot.com/.

Review translated automatically

Reliable opinion

2017-04-15, 16:33

View original

Roman

Wasp M52 1964 and WFM M06 S34 CARTRICULAR PLUG COMPLIANTED WITH ORIGINAL EXECUTION VERY IMPORTANT RECOMMENDED. AFTER INSTALLATION IN CARBURETOR NEEDLE WORKS PROPERLY. CHECK VALVE TIGHT. THE NEEDLE CONE MADE CORRECTLY.

Review translated automatically

Reliable opinion