Motorcycle cylinder & cylinder head sets
Romet Ogar 200

2017-04-24, 18:28

View original

Kacper

I ordered not long ago a set of the entire top of the engine for "jawka" 50. The piston is made of such poor material that when I put on the rings the whole was scratched. The rings are made of such a weak material that they did not withstand even the simplest fitting into place. (I have already put the rings on many types of engines and know how it is done) In the cylinder casting in the intake channels of the fuel-air mixture there are residues from the casting mold. If someone does not remove them, the engine will significantly lose power. When I put the head on the cylinder this one should go into its place and fit perfectly, and here the play is such that I don't know if I can install it at all. When I wanted to put a pin in the piston this one turned out to be too big and I had to buy another one from the same company - Almot. The other pin is so small that it literally flies through its place, I should add that the repurchased pin was supposed to be 14 mm in size, but I guess something didn't work out.

Review translated automatically

Reliable opinion

2018-03-30, 11:02

View original

Kacper

Romet ogar 200 1984. Everything fits very well cylinder fits perfectly in the cartridges, piston and head also very well made, the only reservation to the pin, minimally too big and had to grind a little, otherwise very good products.

Review translated automatically

Reliable opinion

2018-05-18, 08:21

View original

Emil

Ogar 200, 1986. Everything fit perfectly, appearance perfect and best of all is my steed is now closing the meter. Reaching the elements after driving 200 km. I highly recommend to buy such a set. Greetings

Review translated automatically

Reliable opinion