Forgot password
Order status
Free delivery from 150 euro
Motorcycle electrical & lighting
Romet Kadet 50
Options +3 
Browse by manufacturer
Products reviews
WSK 1969 year b1, the so-called two-frame. Junak m10 1963 and 1965 SHL 1966 and 1967 All these models have such bulbs. This product rarely burns out for me. The light gives good, installation oki so I recommend and greetings.
Review translated automatically
Reliable opinion
My machine is a 1982 ROMET OGAR 205 with a capacity of 50cc. Signal revelation, gives a slightly louder signal than the original so that everyone can hear it from a distance. The signal fits nicely to the frame of my ROMET.
Review translated automatically
Reliable opinion
WSK 125 B3 1977. In the absence of the original signal - this one fits perfectly. It is smaller, but makes up for it with sound. Installation without problems - price and quality revelation.
Review translated automatically
Reliable opinion
Pipe not bad but fragile fully shielded candle clamp only on the thread so the thread is destroyed price adekfatna to quality
Review translated automatically
Reliable opinion
As for such a low price it is worth buying fits perfectly to Romet ogar 205 so far works well. recommend.
Review translated automatically
Reliable opinion
Simson s51. Fulfills its purpose and on top of that a cool feature.
Review translated automatically
Reliable opinion
I own Motorynka Romet Pony M-2 Motorcycle.The capacity of the engine is 49.8 cm, and the year of production is 1980.The product made in very good quality, I recommend to all buyers. I have already ordered Motorcycle parts from this store a couple of times, and not only for Motorynka, but for other Motorcycles too.I think that's enough, the products from this store I rate 100%.There were no delays with the shipment, or any complications, I recommend to all buyers!
Review translated automatically
Reliable opinion
I own a Romet Kadet and decided to restore it, the problem turned out to be the lamp which did not survive the test of time fortunately at Gmoto I found what I was looking for although I was not sure if parts for such old mopeds are available, installation was easy put the bulb in, connect three wires and you can ride, the quality of the lamp is very good and delivery to the house was fast and also trouble-free I recommend.
Review translated automatically
Reliable opinion
Romet Kadet , the capacitor fits in place of the old one without reservation, the installation went without a problem. Wire minimally shorter than the original about 3mm, but reaches the same with the same arrangement in the spark gap. Remember during installation to soak the felt in oil and properly bend it to adhere to the magnet cam (if you install without bending it will not lubricate).
Review translated automatically
Reliable opinion
Ignition pipe bought for a WSK 125 motorcycle, at first glance it looks perfect, a very important advantage is the covers to protect against moisture or driving in the rain. Why aesthetics "could be better", because the workmanship is good, but not refined. The important thing is that it works as it should, and I am also very satisfied with the service of the GMoto store, also recommend.
Review translated automatically
Reliable opinion
Romet Ogar 205 from 1990.I received this smaller capacitor with a length of 22 mm , it has a shorter wire and there was a problem with connecting it to the coil.After talking to the store staff I was immediately sent the longer capacitor -27 mm without any additional cost.This capacitor has a wire 5 mm longer and fits perfectly to the above type of Romet. I recommend this store.
Review translated automatically
Reliable opinion
Jawa 50 type 20, I recommend to everyone. At first I thought it would be disgusting to ride with a glowing pipe, but this is nonsense. If a person does not look closely, the light will not see. And from the point of view of operation it is a super solution. You don't have to unscrew the spark plug to check if there is a spark. I sincerely recommend and install in all my Jawkas and Rometas.
Review translated automatically
Reliable opinion
A capacitor is an important component in an electrical system. It is really worth replacing from time to time preventively. Fits into a rometa ogar 205, a little work to put on (pulling off the cover, magneto, etc.), but there were no problems with fitting into the spark gap. After installation, the whole installation works well. Romet Ogar 205, year of manufacture 1987
Review translated automatically
Reliable opinion
Hello. The materials I bought were matched to an old garden tractor engine. Everything was great. I was missing only full dimensioning for example pistons , rings, shaft. But this I understand because the parts are for specific engine Brands. After tel contact that the seller everything matched. Thank you Greetings and highly recommend.
Review translated automatically
Reliable opinion
Hello. The materials I bought were matched to an old garden tractor engine. Everything was great. I was missing only full dimensioning for example pistons , rings, shaft. But this I understand because the parts are for specific engine Brands. After tel contact that the seller everything matched. Thank you Greetings and highly recommend.
Review translated automatically
Reliable opinion
The signal fits the WSK 125 motorcycle perfectly - it replaces the weak factory horn. I will place it in the housing of the original one and without changing the appearance of the motorcycle I will be sure that I can be heard ;) I recommend the product - it is well made and serves its purpose in 101%. For these few zlotys I could not find anything better.
Review translated automatically
Reliable opinion
The lamp performed very correctly as a faithful copy of the original. It lies on the fender at a satisfactory level, admittedly with a slight gap between, but personally it does not bother me. I used a total of only the base of the lamp and with the original shade it blends practically perfectly. I heartily recommend it!
Review translated automatically
Reliable opinion
I own a 2008 Yamaha TZR 50 brand motorcycle the installation of the product was fabulously easy no effort required the product fulfilled its task 100% if someone is looking for an ignition pipe I recommend this model, because it is an excellent quality product. I heartily recommend and greetings.
Review translated automatically
Reliable opinion
Romet Kadet 87. Does not fit in the original base. Too large diameter of locating pins. A failure! Execution poor. Spacing of screws-fits. Cables very thin. Not a Polish manufacturer as I was assured. Goods to return. I do not recommend this coil, avoid from afar!
Review translated automatically
Reliable opinion
The supplier showed professionalism regarding the preparation AND delivery of the shipment of parts for Junak M10. I was very impressed by the electronic notification system of the status of the order until delivery to the addressee. Very fast delivery and without courier.
Review translated automatically
Reliable opinion
For the mosquito 2350 with the s38 engine (egg), the coil purchased does not fit in the holes of the spark arrestor (the spacing of the pins is wider by about 0.5mm, which makes it impossible to install without interference from a file). As for the materials, I have no major complaints, however, the wire could be a little longer.
Review translated automatically
Reliable opinion
Lambretta C125 1951 year of production. The wrench is very good, short, only with it I can reach the candle. In addition, it has hexagonal sockets cut in the handle to handle bolts and nuts in sizes often encountered. The wrench fits very much with the climate of my old scooter.
Review translated automatically
Reliable opinion
Wsk 125 gil. Trying to restore it after 20 years of sleep in garage. Had to change spark plug. Chose tool randomly; I was a bit worried, that spark plug key won' t fit cause engine head looked kind of big, but it fit just fine. Spark changed. We have ignition :).
Review translated automatically
Reliable opinion
I own a 1988 Romet Ogar 200, I needed a new bulb and decided on this very model. The replacement went very smoothly, everything fits perfectly :) the quality is visible to the naked eye. It shines great and I no longer have to worry and riding in the evening :)
Review translated automatically
Reliable opinion
Mr2375, Ogar 205 and 50-T1 toners. This coil will recall the ignition of any of them in the 2375 has worked for 5 years and I have no complaints. It always required a slight grinding, but that's a minor thing. The best part is that the spark would kill a horse and until you hear it crackle beautifully.
Review translated automatically
Reliable opinion
Mosquito Mosquito s38 1975-purchased parts are of high quality in terms of workmanship, aesthetics, efficiency of operation -I recommend many motorcycles I assemble and with this company super to cooperate-mega efficient shipping 24 hours to the other end of the Polish b.good contact with the seller.RECOMMENDED
Review translated automatically
Reliable opinion
I warmly recommend gmoto.pl store is here a lot of parts for motorcycles and mopeds parts as described and also fit motorcycles fast shipping and also fast turnaround time parts made of good solid materials.
Review translated automatically
Reliable opinion
I bought for my motorcycle works flawlessly and at the same time looks nice. The pipe is held very well so that the motorcycle does not "lose" the spark, the light is also useful during malfunctions, because you can easily see what is broken plug or ignition.
Review translated automatically
Reliable opinion
The pipe checks out, spark ok, no puncture, especially since the vehicle lacks an ignition switch and pulling the pipe takes care of it. There were no kicks (although I know that this should not be done, but well. who is blameless let him be the first. ?
Review translated automatically
Reliable opinion
Romet Ogar 205 The ignition coil is a tragedy. It does not fit in the mounting holes. After reaming the holes and installing the coil, it was impossible to put on the magnet wheel. It was necessary to file the coil. Final mounted worked 50 seconds and died.
Review translated automatically
Reliable opinion
Romet ogar 205, 50 cm³, 1987r The wrench fits nicely with the old tools for my ogar, it's very similar to the ones from the communist era, the only downside is that it's not exactly bent and has a slight play on the spark plug itself, but other than that I recommend it
Review translated automatically
Reliable opinion
Ogar 200 This pipe the only pipe maker will really make you happy. Do you have a problem with the disappearing spark? try to replace the pipe and you will find that the spark will not escape anywhere ! quality good everything fits robukt made aesthetically and nicely.
Review translated automatically
Reliable opinion
I bought this product "in stock" , however, it looks very good. As soon as I mount it somewhere I will write what and how, but I can already see that it will be good as with the previous pipe only that straight mounted to Yamaha Majesty 125 1998 vintage.
Review translated automatically
Reliable opinion
Lights up nicely in a motorcycle, no loss of power or firing can be seen Bought as a spark tester for ignition, among other things in such engines. For the price I recommend as a tester, I do not know how in the long run, but I assume it will last
Review translated automatically
Reliable opinion
Romet Ogar 205, a gadget that makes it much easier to work on the engine during activities such as adjusting the ignition, you can control the spark without unscrewing the spark plug. Once the engine is fired up, it looks striking, especially in the dark.
Review translated automatically
Reliable opinion
Hello, I own two 1985 M-2 motorcycles and one 1987 M-3. I am currently in the process of rebuilding each in turn. The parts I bought from Gmoto met my expectations. They were of good quality and fit without any problems.
Review translated automatically
Reliable opinion
Hello, I recommend the product - Romet rear lamp new type as well as I recommend Gmoto.pl store, fast shipping and quick turnaround time allowed me to install the lamp in my Romet Ogar 205 on the second day. I recommend :)
Review translated automatically
Reliable opinion
Motorcycle 50 ccm,year of production 1986 it is known not the first youth .When starting sometimes the spark disappeared.So it had to be replaced with a new one and I heard the first sounds of the long unheard of engine of my youth
Review translated automatically
Reliable opinion
Unfortunately the glow pipe is not even worth the few zloty. I should return, but not worth the trouble. Generally at slow speeds it still works, at higher speeds it stops conducting - a loose "connection" in the middle.
Review translated automatically
Reliable opinion
It looks cool but required fitting to the old motorcycle lamp housing. A little cutting and sanding and it managed to fit. Perhaps my housing originally had a metal clamp. No less a product I recommend.
Review translated automatically
Reliable opinion