Standard cylinders
WSK 125

2019-01-13, 14:07

View original

Wiesław

WSK 125. The cylinder looks Ok , the piston is like that , I pushed the pin through the piston by hand , but I didn't check it all at work because .The pin is oversized , about 2 mm . I sanded . Unfortunately , this is not the end of the trouble because one ring goes into the cylinder on contact , zero play , and the other is again oversized . Gentlemen please , do not write that I can return the goods , etc . Opinions about pins too long I have already seen here , you do nothing about it . Where do you get such good product reviews from? I suggest you throw out all the imperfections and put on the goods produced with standards , because you do not sell broom , but parts for unicycles .

Review translated automatically

Reliable opinion

2018-04-03, 12:04

View original

Sławomir

Hi. I purchased a cylinder for WSK 125 as a set . I must emphatically state that it was made and solid material . It will certainly serve me for a long time. Everything fits perfectly and presents itself beautifully . There are not the slightest problems with the assembly .

Review translated automatically

Reliable opinion